Correction code NA NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

1. Prepare work area
   Note

   Lay down a soft material to prevent scratching the A surface

   

2. Identify center tabs of roof applique
   Note

   Center tabs have narrower channel then outer tabs

   

   

3. Enlarge opening of roof applique center tabs
   Note

   4x tabs, Use a rotary tool with a narrow grinding bit, Set rotary tool to low speed then enlarge opening to 5mm, Ensure opening in ground flush to bottom surface, Clean any debris once complete