2026-01-26

Pedestrian Warning Speaker (Remove and Replace)

Correction code 2121012111 2121012112 FRT 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-01-26: Added ODIN routine to configure speaker.

Remove

  1. Remove the rear fascia. See Rear Fascia (Remove and Install).
  2. Release the connector lock, and then disconnect the pedestrian warning speaker electrical connector.
  3. Remove the screws (x3) that attach the pedestrian warning speaker to the vehicle, and then remove the speaker from the vehicle.
    2 Nm (1.5 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 socket

Install

  1. Position the pedestrian warning speaker into the vehicle, and then install the screws (x3) that attach the speaker to the vehicle.
    2 Nm (1.5 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 socket
  2. Connect the pedestrian warning speaker electrical connector, and then engage the connector lock.
  3. Install the rear fascia. See Rear Fascia (Remove and Install).
  4. Run PROC_ICE_X_SET-PEDESTRIAN-WARNING-SPEAKER-CONFIGvia Toolbox:(link)