2026-08-09

Beltline Assembly - Door Panel - Front - LH (Remove and Replace)

Correction code 1513047072 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2024-12-10: Added caution to not use too much force when releasing the trim from the door assembly. Updated RGB address routine steps from Toolbox to vehicle UI.
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Install

  1. Install the LH beltline assembly. See Beltline Assembly - Door Panel - Front - LH (Remove and Install).
  2. Place the vehicle into Service Mode. See Service Mode.
  3. Unlock the vehicle Gateway. See Gateway (Unlock).
  4. On the vehicle touchscreen, navigate to Service Mode > Mid Voltage > Interior Lighting > Address RGB Lights, tap Run, and allow the routine to complete.
    Note
    Verify that the vehicle firmware is version 2024.44 or later.
    Note
    Close the routine once complete.
  5. Exit Service Mode. See Service Mode.
  6. Raise the LH front window and close the LH front door.