ABS Module and ESC Sensor - Wheel Speed Sensor - Front - LH (Remove and Install)
Correction code 3310007041 3310007042 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Remove
- Open the LH front door and lower the LH front window.
- Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
- Remove the LH front wheel. See Wheel Assembly (Remove and Install).
-
Remove the bolt that attaches the LH
front wheel speed sensor to the LH front knuckle, disconnect the electrical connector,
and then remove the sensor from the vehicle.Tip: Use of the following tool(s) is recommended:
- Torx T30 socket
Install
-
Position the LH front wheel speed sensor to the LH front knuckle, connect the
electrical connector, and then install the bolt that attaches the sensor to the
knuckle.Tip: Use of the following tool(s) is recommended:
- Torx T30 socket
- Install the LH front wheel. See Wheel Assembly (Remove and Install).
- Remove the vehicle from the lift. See Raise Vehicle - 2 Post Lift.
- Raise the LH front window and close the LH front door.