23/07/2024 17:28:44

Front and Rear Door Latch and Striker - Door Latch - Front LH (Remove and Install)

Correction code 1133041021 FRT 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the LH front door closeout panel. See Front and Rear Door Glass Regulator - Front Door LH Door Closeout Panel (Remove and Install).
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to remove the window regulator from the closeout panel assembly.
  2. Disconnect the closure connector harness from the LH front door latch.
  3. Remove the bolts that attach the LH front door latch to the LH front door.
    13 Nm (9.6 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T30 socket
  4. Release the grommet, and the remove the LH front door latch from the door assembly.

Install

  1. Position the LH front door latch into the door assembly, and secure the grommet.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use the tab on emergency release to guide the grommet.
  2. Install the bolts that attach the LH front door latch to the LH front door.
    13 Nm (9.6 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T30 socket
  3. Connect the closure connector harness from the LH front door latch.
  4. Install the LH front door closeout panel assembly. See Front and Rear Door Glass Regulator - Front Door LH Door Closeout Panel (Remove and Install).