2024-07-23

Window Regulator, 48V Q-Motor (Remove and Install)

Correction code 1150040101 1150040102 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Place the vehicle into Service Mode via the UI. See Service Mode.
  3. Remove the LH front door beltline assembly. See Beltline Assembly - Door Panel - Front - LH (Remove and Install).
  4. Remove the LH front door trim. See Panel - Door Trim - Front - LH (Remove and Install).
  5. Connect an external window switch tool to the LH front door.
  6. Use a pocket screwdriver to manually latch the LH front door.
  7. Raise the LH front window.
  8. Disconnect MV power. See Mid-Voltage Power (Disconnect and Connect) (Modify).
  9. Remove the bolts (x3) that attach the LH front door window regulator motor to the door assembly, release the connector lock and disconnect the electrical connector, and then remove the motor from the vehicle.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 socket

Install

  1. Position the LH front door window regulator motor to the door assembly, connect the electrical connector and engage the connector lock, and then install the bolts (x3) that attach the motor to the vehicle.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 socket
  2. Reconnect MV power. See Mid-Voltage Power (Disconnect and Connect) (Modify).
  3. Pull the manual release cable away from the vehicle to unlatch the LH front door.
  4. Install the LH front door trim. See Panel - Door Trim - Front - LH (Remove and Install).
  5. Install the LH front door beltline assembly. See Beltline Assembly - Door Panel - Front - LH (Remove and Install).
  6. Calibrate window
    Informational PurposesAn informational icon, calling your attention
    Note
    Press and hold down selected window for 15 seconds. Roll up window and hold for 15 seconds. Test window by hard pressing to see if auto roll function works.
  7. Raise the LH front window and close the LH front door.