Pump - Washer - Windshield (Remove and Install)
Correction code
1750020311
0.12
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.NOTE:
See Ergonomic Precautionsfor safe
and healthy working practices.
Remove
- Remove the frunk assembly. See Frunk Assembly (Remove and Install).
-
Release the clip that attaches the
camera nozzle hose to the washer pump, and then disconnect the hose from the washer
pump.
-
Release the clip that attaches the
windshield washer hose to the washer pump, and then disconnect the hose from the washer
pump.
-
Disconnect the washer pump electrical
connector.
-
Release the washer pump from the
washer tank, and then pull the washer pump upward to remove it from the vehicle.
Install
-
Position the washer pump into the
vehicle, and then secure the pump to the washer tank.
-
Connect the washer pump electrical
connector.
-
Connect the windshield washer hose to
the washer pump, and then secure the clip.
-
Connect the camera nozzle hose to the
washer pump, and then secure the clip.
- Install the frunk assembly. See Frunk Assembly (Remove and Install).