2024-07-23

Front Energy Absorber - Support Bracket - Center (Remove and Install)

Correction code 1001050041 1001050042 FRT 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the front fascia assembly. See Front Bumper Fascia - Front Fascia (Remove and Install).
  2. Release the clips (x2) that attach the FEM harness to the center support bracket.
  3. Remove the bolts (x3) that attach the center support bracket to the vehicle, and then remove the bracket from the vehicle.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the center support bracket to the vehicle, and then install the bolts (x3) that attach the bracket to the vehicle.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Install the clips (x2) that attach the FEM harness to the center support bracket.
  3. Install the front fascia assembly. See Front Bumper Fascia - Front Fascia (Remove and Install).