2026-08-09

Interior Door Switch - Front - LH (Remove and Install)

Correction code 1513047051 1513047052 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2024-04-01: Cleaned up topic.
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.
Warning
Cybertruck electronics are powered by a 48V "mid voltage" or "MV" architecture that is designed to improve efficiency. Servicing MV components requires extra knowledge and care in order to avoid personal and/or vehicular harm. Read and understand MV precautions in Electrical Precautions and make sure any required MV-related training courses have been completed, as applicable.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Open the powered frunk.
  3. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Install).
  4. Disconnect MV power. See Mid-Voltage Power (Disconnect and Connect) (Modify).
  5. Remove the LH front beltline assembly. See Beltline Assembly - Door Panel - Front - LH (Remove and Install).
  6. Remove the LH front door trim. See Panel - Door Trim - Front - LH (Remove and Install).
  7. Remove the LH front NVH foam. See NVH Foam - Door - Front - LH (Remove and Install).
  8. Release the clip, and then remove the LH front door release switch from the door trim.
    Note
    x1 electrical connector
    Note
    Slide the switch out of the door trim.

Install

  1. Install the LH front door release switch into the door trim.
    Note
    x1 electrical connector
    Note
    x1 clip
    Note
    Slide the door release switch into the door trim.
  2. Install the LH front NVH foam. See NVH Foam - Door - Front - LH (Remove and Install).
  3. Install the LH front door trim. See Panel - Door Trim - Front - LH (Remove and Install).
  4. Install the LH front beltline assembly. See Beltline Assembly - Door Panel - Front - LH (Remove and Install).
  5. Connect MV power. See Mid-Voltage Power (Disconnect and Connect) (Modify).
  6. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Install).
  7. Close the powered frunk.
  8. Raise the LH front window and close the LH front door.