2024-07-23

Harness - Trim - Door - Front - LH (Remove and Install)

Correction code 1710031051 1710031052 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-04-03: Cleaned up topic.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Cybertruck electronics are powered by a 48V "mid voltage" or "MV" architecture that is designed to improve efficiency. Servicing MV components requires extra knowledge and care in order to avoid personal and/or vehicular harm. Read and understand MV precautions in Electrical Precautions and make sure any required MV-related training courses have been completed, as applicable.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Open the powered frunk.
  3. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Install).
  4. Disconnect MV power. See Disconnect MV Power (Modify).
  5. Remove the LH front beltline assembly. See Beltline Assembly - Door Panel - Front - LH (Remove and Install).
  6. Remove the LH front door trim. See Panel - Door Trim - Front - LH (Remove and Install).
  7. Remove the LH front NVH foam. See NVH Foam - Door - Front - LH (Remove and Install).
  8. Remove the LH front trim electrical harness from the door trim.
    Informational PurposesAn informational icon, calling your attention
    Note
    x4 electrical connectors
    Informational PurposesAn informational icon, calling your attention
    Note
    x4 tabs

Install

  1. Install the LH front trim electrical harness onto the door trim.
    Informational PurposesAn informational icon, calling your attention
    Note
    x4 electrical connectors
    Informational PurposesAn informational icon, calling your attention
    Note
    x4 tabs
  2. Install the LH front NVH foam. See NVH Foam - Door - Front - LH (Remove and Install).
  3. Install the LH front door trim. See Panel - Door Trim - Front - LH (Remove and Install).
  4. Install the LH front beltline assembly. See Beltline Assembly - Door Panel - Front - LH (Remove and Install).
  5. Connect MV power. See Disconnect MV Power (Modify).
  6. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Install).
  7. Close the powered frunk.
  8. Raise the LH front window and close the LH front door.