23/07/2024 17:29:47

Front Grille and Applique - Foam Seal - Upper/Lower (Remove and Install)

Correction code 1001052051 FRT 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the front lower fascia. See Front Bumper Fascia - Front Fascia (Remove and Install).
  2. Remove and discard the upper foam seal.
    Informational PurposesAn informational icon, calling your attention
    Note
    Adhesive may tear off from the foam.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove any remaining adhesive.
    Informational PurposesAn informational icon, calling your attention
    Note
    Wipe the area with IPA wipes.

Install

  1. Peel the adhesive backing off of the new upper foam seal, and then install the foam seal onto the grille.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the foam is aligned with side foam seals.
    Informational PurposesAn informational icon, calling your attention
    Note
    Wet out the adhesive with a roller.
  2. Install the front lower fascia. See Front Bumper Fascia - Front Fascia (Remove and Install).