2024-07-23
Foam - Back Rest Insert - 2nd Row Seat (Remove and Install)
Correction code
1308005091
1308005092
FRT
0.96
NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created.
NOTE: See Personal Protection to make sure you
are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy working practices.
Warning
This procedure is a DRAFT.
Although it has been validated, Warnings and Cautions might be missing. Follow safety
requirements and use extreme caution when working on or near High Voltage systems and
components.
Remove
- Remove the LH 2nd row seat back assembly. See Seat Back Assembly - 2nd Row Seat - LH (Remove and Install).
- Remove the LH 2nd row seat back insert trim. See Trim - Back Rest Insert - 2nd Row Seat (Remove and Install).
-
Align the locking bar with the slots
in the LH 2nd row seat back insert foam, release the foam from the seat back assembly,
and then remove the foam from the assembly.
Install
-
Position the LH 2nd row seat back
insert foam into the seat frame assembly, and then align the locking bar to secure the
foam to the assembly.
- Install the LH 2nd row seat back insert trim. See Trim - Back Rest Insert - 2nd Row Seat (Remove and Install).
- Install the LH 2nd row seat back assembly. See Seat Back Assembly - 2nd Row Seat - LH (Remove and Install).