23/07/2024 17:23:09

1st Row Seat Belts - 1R LH Retractor, Black (Remove and Install)

Correction code 2005001011 2005001012 2005001021 2005001022 FRT 0.78 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the LH 1st row seatbelt webguide. See 1st Row Seat Belts - Single Fastener Seatbelt Webguide (Remove and Install).
  2. Remove and discard the bolt that attaches the LH upper seatbelt to the body bracket.
    30 Nm (22.1 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T50 socket
  3. Release the connector locks, and then disconnect the LH 1st row retractor pretensioner connectors (x2).
    Informational PurposesAn informational icon, calling your attention
    Note
    Slide both orange locking tabs on the sides of the connector towards the rear of the connector at the same time to release the connector.
  4. Remove and discard the bolt that attaches the LH 1st row retractor to the vehicle, and then remove the retractor from the vehicle.
    45 Nm (33.2 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 13 mm socket

Install

  1. Position the LH 1st row retractor into the vehicle, and then install a new bolt that attaches the retractor to the vehicle.
    45 Nm (33.2 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 13 mm socket
  2. Connect the LH 1st row retractor pretensioner connectors (x2), and then engage the connector lock..
  3. Position the LH upper seatbelt to the body bracket, and then install a new bolt that attaches LH upper seatbelt to the body bracket.
    30 Nm (22.1 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T50 socket
  4. Remove the LH 1st row seatbelt webguide. See 1st Row Seat Belts - Single Fastener Seatbelt Webguide (Remove and Install).