Seal - Quarter Glass - Front - LH (Remove and Install)
Correction code
1020030011
FRT
0.06
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Open the LH front door.
- Partially release the LH door primary seal.
-
Release the clips (x2) and adhesive
patch that attach the LH quarter glass seal to the vehicle, and then remove the seal
from the vehicle.
CAUTIONBe careful not to tear the clips out of the seal.NoteRelease the lower clip first, and then pull the seal rearwards to release adhesive and seal.
Install
-
Position the LH quarter glass seal
into the vehicle, and then install the clips (x2) and adhesive patch that attaches the
seal to the vehicle.
NoteSecure the upper clip first, and then push the seal into groove on quarter glass. Once the upper section is secure, push the adhesive section behind the glass, and then secure the lower clip.
-
Secure the LH door primary seal.
NoteMake sure the seal is fully seated.
- Close the LH front door.