23/07/2024 17:28:58

Front and Rear Garnish - Carrier - Rear Fender Flare Aft - RH (Remove and Install)

Correction code 1220043131 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the RH rear fender flare. See Front and Rear Garnish - Rear Fender Flare - RH (Remove and Install).
  2. Remove the clips (x2) that attach the RH rear wheel liner to the RH rear aft fender flare carrier.
  3. Remove the bolts (x2) that attach the RH rear aft fender flare carrier to the vehicle, and then remove the carrier from the vehicle.
    7 Nm (5.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the RH rear aft fender flare carrier to the vehicle, and then install the bolts (x2) that attach the carrier to the vehicle.
    7 Nm (5.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Install the clips (x2) that attach the RH rear wheel liner to the RH rear aft fender flare carrier.
  3. Install the RH rear fender flare. See Front and Rear Garnish - Rear Fender Flare - RH (Remove and Install).