23/07/2024 17:23:48

A-B-C Post Interior Trim - B-Pillar Upper Trim Bezel - LH (Remove and Install)

Correction code 1518006191 1518006192 1518006201 1518006202 FRT 0.84 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open LH doors and lower the LH windows.
  2. Fold up the LH 2nd row seat.
  3. Partially release the LH rear primary door seal.
  4. Release the clip and datum that attach the lower portion of the LH lower C-pillar trim to the vehicle.
  5. Remove the front header trim. See Headliner Trim - Front Header Trim (Remove and Install).
  6. Remove the LH mid A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Mid Trim - LH (Remove and Install).
  7. Remove the LH lower A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Lower Trim - LH (Remove and Install).
  8. Remove the LH IP quarter panel assembly. See Dash Panel - Quarter Panel Assembly - LH (Remove and Install).
  9. Remove the LH upper A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Upper Trim - LH (Remove and Install).
  10. Remove the LH A-pillar forward trim. See A-B-C Post Interior Trim - A-Pillar Forward Trim - LH (Remove and Install).
  11. Move the LH front seat fully forward.
  12. Remove the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  13. Disconnect MV power. See Disconnect MV Power.
  14. Remove the rear header trim. See Headliner Trim - Rear Header Trim (Remove and Install).
  15. Remove the LH cantrail trim. See Headliner Trim - Cantrail Trim - LH (Remove and Install).
  16. Remove the LH curtain airbag. See Side Air Bags - Curtain Airbag, LH (Remove and Install).
  17. Remove the LH lower B-pillar trim. See A-B-C Post Interior Trim - B-Pillar Lower Trim - LH (Remove and Install).
  18. Remove the fasteners (x3) and clips (x3) that attach the LH upper B-pillar trim to the vehicle, and then remove the trim from the vehicle.
    2.5 Nm (1.8 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
    • Torx T20 socket
  19. Release the clips (x7) that attach the LH B-pillar bezel to the vehicle, and then remove the bezel from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the bezel from the bottom first, and then slide the bezel out.

Install

  1. Position the LH B-pillar bezel into the vehicle, and then secure the clips (x7) that attach the bezel to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the seat belt is fully seated.
  2. Position the LH upper B-pillar trim to the vehicle, and then install the fasteners (x3) and clips (x3) that attach the trim to the vehicle.
    2.5 Nm (1.8 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
    • Torx T20 socket
  3. Position the LH lower B-pillar trim into the vehicle, and then secure the clips (x11), datums (x4), and seal retainers (x4) that attach the trim to the B-pillar.
  4. Install the LH curtain airbag. See Side Air Bags - Curtain Airbag, LH (Remove and Install).
  5. Install the LH cantrail trim. See Headliner Trim - Cantrail Trim - LH (Remove and Install).
  6. Install the rear header trim. See Headliner Trim - Rear Header Trim (Remove and Install).
  7. Secure the clip and datum that attach the front portion of the LH lower C-pillar trim.
  8. Secure the LH rear primary door seal.
  9. Fold down the LH 2nd row seat.
  10. Raise the LH rear window and close the LH rear door.
  11. Install the LH A-pillar forward trim. See A-B-C Post Interior Trim - A-Pillar Forward Trim - LH (Remove and Install).
  12. Install the LH lower A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Lower Trim - LH (Remove and Install).
  13. Install the LH IP quarter panel. See Dash Panel - Quarter Panel Assembly - LH (Remove and Install).
  14. Install the LH A-pillar upper trim. See A-B-C Post Interior Trim - A-Pillar Upper Trim - LH (Remove and Install).
  15. Install the LH mid A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Mid Trim - LH (Remove and Install).
  16. Install the front header trim. See Headliner Trim - Front Header Trim (Remove and Install).
  17. Reconnect MV power. See Disconnect MV Power.
  18. Install the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  19. Restore the LH front seat back to its original position.
  20. Raise the LH front window and close the LH front door.