Sensor - Level - Washer - Windshield (Remove and Install)
Correction code
1750020711
0.12
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and FRT
listed above reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times
to learn more about FRTs and how they are created.
NOTE: See Personal Protection
to make sure you are wearing proper PPE when performing the procedure
below.
NOTE:
See Ergonomic Precautions for
safe and healthy working practices.
Remove
- Remove the frunk assembly. See Frunk Assembly (Remove and Install).
-
Disconnect the washer level sensor
electrical connector, and then remove the sensor from the vehicle.
Install
-
Install the washer level sensor into
the vehicle, and connect the electrical connector.
- Install the frunk assembly. See Frunk Assembly (Remove and Install).