2026-08-09

Applique - Upper - Fascia (Remove and Install)

Correction code 1220035171 1220035172 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Remove the powergate fascia assembly. See Powergate Fascia (Remove and Install).
  2. Remove the nuts (x13) that attach the upper fascia applique assembly to the vehicle, and then remove the applique from the vehicle.
    1.5 Nm (1.1 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the upper fascia applique assembly to the vehicle, and then install the nuts (x13) that attach the applique to the vehicle.
    1.5 Nm (1.1 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Install the powergate fascia assembly. See Powergate Fascia (Remove and Install).