2026-05-13

Bed Side Wall - LH (Standard) (Remove and Install)

Correction code NEW NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.
  • 2026-05-08: Released new procedure.
  1. Open the tonneau cover.
  2. Open the tailgate.
  3. Open the LH front door and lower the LH front window.
  4. Remove the bed floor assembly. See Bed Floor Assembly (Long Range) (Remove and Install).
  5. Remove the LH sail applique. See Sail Applique - RH (Remove and Install) (Post 11/4/2024).
  6. Remove the LH tonneau water management seal. See Water Management Seal - LH - Center - Tonneau (Remove and Install)
  7. Remove the upper bedside wall assembly. See Bed Side Wall Assembly - Upper - LH (Remove and Install).
  8. Remove the LH rear bed closeout. See Bed Closeout - Rear - LH (Remove and Install).
  9. Remove LH lower bed side wall
    Informational PurposesAn informational icon, calling your attention
    Note
    1x bolt, 15mm, 46 Nm, 2x bolts, T45, 36 Nm, 4x bolts, 10mm, 11 Nm, 2x nuts, 10mm, 7 Nm, 4x clips, 1x fastener cover, 3x connectorsRelease locking tabs, Disconnect bed outlet connectors from bed side wall and ground strap, 1x bolt, 10mm, 10 Nm, 2x connectors, Release locking tabs, Slide lock to release.
  10. Install LH lower bed side wall
    Informational PurposesAn informational icon, calling your attention
    Note
    1x bolt, 15mm, 46 Nm, 2x bolts, 13mm, 36 Nm, 4x bolts, 10mm, 11 Nm, 2x nuts, 10mm, 7 Nm, 4x clips, 1x fastener cover, 1x connector, Secure locking tabs, Connect bed outlet connectors onto bed side wall and ground strap, 1x bolt, 10mm, 10 Nm, 2x connectors, Secure locking tabs, Slide lock to secure, Recommend assistance
  11. Install the LH rear bed closeout. See Bed Closeout - Rear - LH (Remove and Install).
  12. Install the upper bedside wall assembly. See Bed Side Wall Assembly - Upper - LH (Remove and Install).
  13. Install the LH tonneau water management seal. See Water Management Seal - LH - Center - Tonneau (Remove and Install)
  14. Install the LH sail applique. See Sail Applique - RH (Remove and Install) (Post 11/4/2024).
  15. Install the bed floor assembly. See Bed Floor Assembly (Long Range) (Remove and Install).