Wheel Liner - Rear - LH (Remove and Install)
Correction code
1201130031
1201130032
1201130041
1201130042
FRT
0.24
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the LH rear fore fender flare. See Fender Flare - Fore - Rear - LH (Remove and Install).
- Remove the LH rear aft fender flare. See Fender Flare - Aft - Rear - LH (Remove and Install).
-
Remove the push clips (x19) and push
nuts (x5) that attach the LH rear wheel liner to the vehicle, and then remove the liner
from the vehicle.
NoteCut the push nuts with diagonal cutters. Discard the push nuts after removal.
Install
-
Position the LH rear wheel liner into the vehicle, and then install the push clips
(x19) and new push nuts (x5) that attach the liner to the vehicle.
- Install the LH rear aft fender flare. See Fender Flare - Aft - Rear - LH (Remove and Install).
- Install the LH rear fore fender flare. See Fender Flare - Fore - Rear - LH (Remove and Install).