Correction code 21151007 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

1. Remove front cover from Car Computer
   Note

   6x bolts, TP8, 0.7 Nm

   

   

2. Remove the Infotainment PCBA from the housing
   Note

   17x bolts, TP8, 0.7 Nm

   

3. Drill through CPU and eMMC
   Note

   Place a block of wood under the PCBA and use an 8mm drill bit (or similar size) to drill into the center of the CPU and eMMC and throughthe PCBA

   

4. Remove back cover
   Note

   6x bolts, TP8, 0.7 Nm

   

   

5. Remove DAS PCBA from housing
   Note

   19x bolts, TP8, 0.7 Nm

   

6. Drill through hardware Turbos and UFS chips
   Note

   Place a block of wood under the PCBA and use an 8mm drill bit (or similar size) to drill into the center of each Turbo and UFS chip andthrough the PCBA

   

7. Capture images of drilled out chips as needed and upload to MRB attachment section
   Note

   After confirming the MRB, A file can be attached using the lookup tile, Enter in the MRB#, Click on the MRB# to view the MRB details, Click on "Choose File" under the attachment section, Select the files, Click "Open", Click "Save" after all files are uploaded
8. Dispose of Car Computer