2024-07-23
Wheel Arch Liners - Front Wheel Liner - LH (Remove and Replace)
Correction code
1201130011
1201130012
1201130021
1201130022
FRT
0.18
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Warning
This procedure is a DRAFT.
Although it has been validated, Warnings and Cautions might be missing. Follow safety
requirements and use extreme caution when working on or near High Voltage systems and
components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
Remove
- Open the LH front door and lower the LH front window.
-
Set the air suspension ride height to
“Very High”.
NoteOn the vehicle touchscreen, navigate to Controls > Suspension > Off Road > Very High.
-
Remove the bolts (x2) and push clip
that attach the LH front wheel liner to the HV battery chinstrap, and then release the
liner.6 Nm (4.4 lbs-ft)TIpUse of the following tool(s) is recommended:
- 10 mm socket
- Remove the push clips (x14) that attach the LH front wheel liner to the fender flare carrier and fascia, and then release the liner.
- Remove the push nuts (x6) that attach the LH front wheel liner to the vehicle.
- Maneuver the LH front wheel liner to clear the fender flare and tire, and then remove the liner from the vehicle.
Install
- Maneuver the LH front wheel liner to clear the fender flare and tire and into position.
-
Install the push nuts (x6) that attach the LH front wheel liner to the vehicle.
NoteReplace any damaged nuts.
- Position the LH front wheel liner to the fender flare carrier and fascia, and then install the push clips (x14).
-
Position the LH front wheel liner to the HV battery chinstrap, and then install the
bolts (x2) and push clip.6 Nm (4.4 lbs-ft)TIpUse of the following tool(s) is recommended:
- 10 mm socket
-
Set the air suspension ride height to
“Medium”.
NoteOn the vehicle touchscreen, navigate to Controls > Suspension > ''Medium".
- Raise the LH front window and close the LH front door.