23/07/2024 17:23:27

2nd Row Seat Back Hardware - 2R Seat Cushion Release Buckle Strap (Remove and Install)

Correction code 1305003051 1305003052 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH rear door and lower the LH rear window.
  2. Release the clips (x3), tabs (x7), and datums (x4) that attach the LH lower C-pillar trim to the C-pillar.
    Informational PurposesAn informational icon, calling your attention
    Note
    Starting at the door sill, pull upward, and then forward to release.
    Informational PurposesAn informational icon, calling your attention
    Note
    Leave the trim attached to the seat belt.
  3. Remove the LH 2nd row shoulder cover. See 2nd Row Seat Back Hardware - 2nd Row Seat Shoulder Cover - LH (Remove and Install).
  4. Remove the LH 2nd row seatback outboard bolster. See 2nd Row Seat Assemblies - 2R Seat Side Bolster LH (Remove and Install).
  5. Remove the clip that attaches the LH 2nd row seat cushion release buckle strap guide to the vehicle, and then position the strap guide aside.
  6. Release the LH 2nd row seat cushion release buckle strap from the lever.
    Informational PurposesAn informational icon, calling your attention
    Note
    Compress the material, and then twist away to release from the groove.
  7. Pull the LH 2nd row seat cushion release buckle strap from the guide opening to remove it from the assembly.

Install

  1. Install the LH 2nd row seat cushion release buckle strap into the guide.
    Informational PurposesAn informational icon, calling your attention
    Note
    Push the strap through the guide opening.
  2. Slide the LH 2nd row seat cushion release buckle strap onto the lever, and then compress the material and twist inward to secure it to the groove.
  3. Position the LH 2nd row seat cushion release buckle strap guide to the vehicle, and then install the clip.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the strap is not twisted.
  4. Install the LH 2nd row seatback outboard bolster. See 2nd Row Seat Assemblies - 2R Seat Side Bolster LH (Remove and Install).
  5. Position the LH 2nd row shoulder cover into the vehicle, and then fasten the clips (x7) that attach the cover to the vehicle.
  6. Position the LH lower C-pillar trim to the C-pillar, and then secure the clips (x3), tabs (x7), and datums (x4) that attach the trim to the C-pillar.
  7. Raise the LH rear window and close the LH rear door.