2024-07-23
Front and Rear Door Seals - Outer Waist Belt Seal, Rear Door, LH (Remove and Install)
Correction code
1170042061
1170042062
1170042071
1170042072
FRT
0.06
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Warning
This procedure is a DRAFT.
Although it has been validated, Warnings and Cautions might be missing. Follow safety
requirements and use extreme caution when working on or near High Voltage systems and
components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
Remove
- Open the LH rear door and lower the LH rear window.
- Remove the LH rear door beltline assembly. See Rear Door Trim Pad - Beltline Assembly - LH (Remove and Install).
- Remove the LH rear door inner waist belt seal. See Front and Rear Door Seals - Inner Waist Belt Seal, Rear Door, LH (Remove and Install).
-
Pull the LH rear door outer waist belt
seal away from the door assembly to remove it.
Install
-
Align the LH rear door outer waist
belt seal onto the door assembly, and then press the seal into the door assembly to seat
it.
- Install the LH rear door inner waist belt seal. See Front and Rear Door Seals - Inner Waist Belt Seal, Rear Door, LH (Remove and Install).
- Install the LH rear door beltline assembly. See Rear Door Trim Pad - Beltline Assembly - LH (Remove and Install).
- Raise the LH front window and close the LH front door.