2024-07-23

Underhood Apron - LH (Remove and Install)

Correction code 1225127011 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Remove the frunk assembly. See Frunk Assembly (Remove and Install).
  3. Release the clips (x3) that attach the LH underhood apron to the vehicle, and then remove the apron from the vehicle.

Install

  1. Position the LH underhood apron into the vehicle, and then secure the clips (x3) that attach the apron to the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Replace any damaged or broken clips.
  2. Install the frunk assembly. See Frunk Assembly (Remove and Install).
  3. Raise the LH front window and close the LH front door.