Front Brake Rotors - Calipers and Pads - Front Brake Shield - LH (Remove and Install)

Correction code 3301044041 FRT 0.72 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
The procedure for the removal and installation of the front brake shield is the same as the procedure of the removal and installation of the hub assembly. See Front Knuckle - Hub and Bearing - Driven Hub - 6X139.7mm PCD - 180mm Flange (Remove and Install).