23/07/2024 17:25:35

Audio Speakers - Assembly Microphone Telephony (Remove and Install)

Correction code 2121012101 2121012102 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Remove the front header trim. See Headliner Trim - Front Header Trim (Remove and Install).
  3. Remove the LH mid A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Mid Trim - LH (Remove and Install).
  4. Remove the LH upper A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Upper Trim - LH (Remove and Install).
  5. Disconnect the LH microphone telephony assembly electrical connector.
  6. Remove the screws (x2) that attach the LH microphone telephony assembly to the LH upper A-pillar trim, and then remove the telephony assembly from the trim assembly.
    1 Nm (.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T15 socket

Install

  1. Position the LH microphone telephony assembly into the LH upper A-pillar trim, and then install the screws (x2) that attach the telephony assembly to the trim assembly.
    1 Nm (.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T15 socket
  2. Connect the LH microphone telephony assembly electrical connector.
  3. Install the LH upper A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Upper Trim - LH (Remove and Install).
  4. Install the LH mid A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Mid Trim - LH (Remove and Install).
  5. Install the front header trim. See Headliner Trim - Front Header Trim (Remove and Install).
  6. Raise the LH front window and close the LH front door.