Axle Seal - Output - Front Drive Unit (Remove and Replace)
Correction code
3901049011
3901049012
FRT
0.60
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and its
associated FRT reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times to
learn more about FRTs and how they are created.
NOTE: See Personal Protection to make
sure you are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy
working practices.
Special tools required for this procedure:
| Part Number | Description |
| 1454928-00-A | Tool, Seal Puller, Adjustable, MS/MX/M3 |
Remove
- Remove the LH halfshaft. See Halfshaft - LH - Front Drive Unit (Remove and Install).
-
Remove the LH front halfshaft output
seal.
NoteUse the seal puller (1454928-00-A) to remove the seal.
Install
-
Install the LH front halfshaft output
seal.
NoteInstall seal to seal driver, and then position the square to the drive unit bore.
- Install the LH halfshaft. See Halfshaft - LH - Front Drive Unit (Remove and Install).