23/07/2024 17:29:04

Front Brake Rotors - Calipers and Pads - Front Brake Rotor (Remove and Install)

Correction code 3301044011 3301044012 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  3. Remove the LH front wheel. See Wheel Assembly (Remove and Install).
  4. Remove the bolt that attaches the LH front brake hose bracket to the knuckle, and then release the bracket from the knuckle.
    10 Nm (7.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm deep socket
  5. Remove the bolts (x2) that attach the LH front caliper to the knuckle, and then use an S-hook hang the caliper aside.
    315 Nm (232.3 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 24 mm socket
  6. Remove the LH front brake rotor from the vehicle.

Install

  1. Position the LH front brake rotor onto the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    The rotor will be loose until the caliper is installed.
  2. With assistance, position the LH front caliper to the knuckle, and then install the bolts (x2) that attach the caliper to the knuckle.
    315 Nm (232.3 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 24 mm socket
  3. Position the LH front brake hose bracket to the knuckle, and then install the bolt that attaches the bracket to the knuckle.
    10 Nm (7.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm deep socket
  4. Install the LH front wheel. See Wheel Assembly (Remove and Install).
  5. Remove the vehicle from the lift. See Raise Vehicle - 2 Post Lift.
  6. Raise the LH front window and close the LH front door.