2026-02-02

Bridge - Track Motor - 1st Row Seat - LH (Remove and Install)

Correction code 13010102601 0.66 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Cybertruck electronics are powered by a 48V "mid voltage" or "MV" architecture that is designed to improve efficiency. Servicing MV components requires extra knowledge and care in order to avoid personal and/or vehicular harm. Read and understand MV precautions in Electrical Precautions and make sure any required MV-related training courses have been completed, as applicable.
  • 2026-01-26: Released new procedure.
  1. Remove the LH front seat assembly from the vehicle. See Seat Assembly - 1st Row - LH (Remove and Install).
  2. Place LH front seat on a protected surface
    Informational PurposesAn informational icon, calling your attention
    Note
    Recommend assistance, Place seat so the underside of the seat can be accessed
  3. Disconnect LH front seat track motor
    Informational PurposesAn informational icon, calling your attention
    Note
    1x connector
  4. Release LH front seat harness from track bridge
    Informational PurposesAn informational icon, calling your attention
    Note
    3x Clips
  5. Remove outboard bolts securing seat track to seat cushion frame
    Informational PurposesAn informational icon, calling your attention
    Note
    2x patch bolts, T45P, 23 Nm, Discard after removal
  6. Release outboard track from bridge motor
    Informational PurposesAn informational icon, calling your attention
    Note
    1x tab, Pry up on bridge tack motor tab and slide outboard seat track away to release
  7. Release track motor bridge from inboard track
    Informational PurposesAn informational icon, calling your attention
    Note
    1x tab, Pry up on track motor bridge tab and slide away from inboard track
  8. Install track motor bridge to inboard seat track
    Informational PurposesAn informational icon, calling your attention
    Note
    1x tab, Track motor cable is keyed square and must be aligned with inboard track, Turn cable by hand to align as needed, Slide track motor bridge into inboard track till fully seated to secure
  9. Install outboard seat track to track motor bridge
    Informational PurposesAn informational icon, calling your attention
    Note
    1x tab, Track motor cable is keyed square and must be aligned with outboard track, Turn cable by hand to align as needed, Slide outboard track into track motor bridge till fully seated to secure
  10. Install outboard bolts securing seat track to seat cushion frame
    Informational PurposesAn informational icon, calling your attention
    Note
    2x patch bolts, T45P, 23 Nm, Install new patch bolts
  11. Secure LH front seat harness to track bridge
    Informational PurposesAn informational icon, calling your attention
    Note
    3x Clips
  12. Connect LH front seat track motor
    Informational PurposesAn informational icon, calling your attention
    Note
    1x connector
  13. Install the LH front seat assembly into the vehicle. See Seat Assembly - 1st Row - LH (Remove and Install).