2024-07-23
Front Seat Covers and Pads - 1R LH Inboard Cybershield Paint (Remove and Install)
Correction code
1307060021
1307060022
1307060011
1307060012
FRT
0.30
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Warning
This procedure is a DRAFT.
Although it has been validated, Warnings and Cautions might be missing. Follow safety
requirements and use extreme caution when working on or near High Voltage systems and
components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
Remove
- Open the LH doors and lower the LH windows.
- Remove the LH front seat assembly from the vehicle. See Front Seat Assemblies - 1st Row Seat Assembly - LH Drive - LH - Black (Remove and Install).
-
Release the clips (x7) that attach the
LH front seat inboard cover to the seat assembly, and then remove the cover from the
seat assembly.
Install
-
Position the LH front seat inboard cover onto the seat assembly, and then engage the
clips (x7) that attach the cover to the seat assembly.
- Install the LH front seat assembly into the vehicle. See Front Seat Assemblies - 1st Row Seat Assembly - LH Drive - LH - Black (Remove and Install).
- Raise the LH windows and close the LH doors.