23/07/2024 17:31:51

Impact and Acceleration Sensors - Single Axis, 480G, Crash Accel, Perpendicular (Remove and Install)

Correction code 2020075031 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Enable Service Mode via the vehicle touchscreen. See Service Mode.
  3. Remove the frunk assembly. See Frunk Assembly (Remove and Install).
  4. Disconnect MV power. See Disconnect MV Power.
  5. Release the connector lock and disconnect the electrical connector, remove the bolt that attaches the LH front end module impact sensor to the vehicle, and then remove the sensor from the vehicle.
    10 Nm (7.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the LH front end module impact sensor into the vehicle, connect the electrical connector and engage the locking tab, and then install the bolt that attaches the sensor to the vehicle.
    10 Nm (7.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Align the locating tab.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Connect MV power. See Disconnect MV Power.
  3. Install the frunk assembly. See Frunk Assembly (Remove and Install).
  4. Exit Service Mode. See Service Mode.
  5. Raise the LH front window and close the LH front door.