07/10/2024 09:57:20

A-B-C Post Interior Trim - C-Pillar Ramp Bracket - LH (Remove and Install)

Correction code 1518006041 1518006042 1518006051 1518006052 FRT 0.54 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-10-07: Updated LH C-pillar ramp bracket fastener torque spec.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Open the LH rear door and lower the LH rear window.
  3. Remove the front header trim. See Headliner Trim - Front Header Trim (Remove and Install).
  4. Remove the LH mid A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Mid Trim - LH (Remove and Install).
  5. Remove the LH IP quarter panel assembly. See Dash Panel - Quarter Panel Assembly - LH (Remove and Install).
  6. Remove the LH upper A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Upper Trim - LH (Remove and Install).
  7. Remove the LH A-pillar forward trim. See A-B-C Post Interior Trim - A-Pillar Forward Trim - LH (Remove and Install).
  8. Move the LH front seat fully forward.
  9. Remove the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  10. Disconnect MV power. See Disconnect MV Power.
  11. Remove the rear header trim. See Headliner Trim - Rear Header Trim (Remove and Install).
  12. Remove the LH cantrail trim. See Headliner Trim - Cantrail Trim - LH (Remove and Install).
  13. Remove the bolt and release the clip that attach the LH airbag to the C-pillar ramp bracket, and then release the airbag from the bracket.
    7 Nm (5.2 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  14. Release the clip that attaches the LH body harness to the C-pillar ramp bracket.
  15. Remove the bolts (x2) that attach the C-pillar ramp bracket to the vehicle, and then remove the bracket from the vehicle.
    4 Nm (2.9 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the C-pillar ramp bracket into the vehicle, and then install the bolts (x2) that attach the bracket to the vehicle.
    4 Nm (2.9 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Install the clip that attaches the LH body harness to the C-pillar ramp bracket.
  3. Install the bolt and secure the clip that attach the LH airbag to the C-pillar ramp bracket.
    7 Nm (5.2 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  4. Install the LH cantrail trim. See Headliner Trim - Cantrail Trim - LH (Remove and Install).
  5. Install the rear header trim. See Headliner Trim - Rear Header Trim (Remove and Install).
  6. Install the LH A-pillar forward trim. See A-B-C Post Interior Trim - A-Pillar Forward Trim - LH (Remove and Install).
  7. Install the LH upper A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Upper Trim - LH (Remove and Install).
  8. Install the LH IP quarter panel assembly. See Dash Panel - Quarter Panel Assembly - LH (Remove and Install).
  9. Install the LH mid A-pillar trim. See A-B-C Post Interior Trim - A-Pillar Mid Trim - LH (Remove and Install).
  10. Install the front header trim. See Headliner Trim - Front Header Trim (Remove and Install).
  11. Reconnect MV power. See Disconnect MV Power.
  12. Install the rear underhood apron. See Underhood Trim - Rear Apron Assembly (Remove and Install).
  13. Raise the LH rear window and close the LH rear door.
  14. Restore the LH front seat back to its original position.
  15. Raise the LH front window and close the LH front door.