2026-08-09

Beltline Assembly - Door Panel - Rear - LH (Remove and Install)

Correction code 1513091081 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2025-10-09: Added steps to run RGB Lights addressing routine.
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH rear door and lower the LH rear window.
  2. Release the clips (x16) and datums (x2) that attach the LH rear beltline assembly to the door assembly, disconnect the electrical connectors (x2), and then remove the beltline assembly from the vehicle.

Install

  1. Position the LH rear beltline assembly to the door assembly, connect the electrical connectors (x2), and then engage the clips (x16) and datums (x2) that attach the beltline assembly to the door.
    Note
    Replace any missing or damaged clips.
  2. Place the vehicle into Service Mode. See Service Mode.
  3. Unlock the vehicle Gateway. See Gateway (Unlock).
  4. On the vehicle touchscreen, navigate to UI > Service > Mid Voltage > Interior Lighting > Address RGB Lights > Run > Close to run the RGB Lights addressing routine.
    Note
    Vehicle software version be 2024.44 or newer.
  5. Exit Service Mode. See Service Mode.
  6. Raise the LH rear window and close the LH rear door.