23/07/2024 17:27:49

Door Harnesses - Harness - Door, Closures Devices (Remove and Install)

Correction code 1710031071 FRT 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door.
  2. Place the vehicle in Service Mode. See Service Mode.
  3. Remove the LH front door trim. See Front Door Trim Pad - Door Trim Front - LH (Remove and Install).
  4. Remove the LH front inner waist belt seal.
    Informational PurposesAn informational icon, calling your attention
    Note
    x6 rubber datums
  5. Remove the LH front door grommets (x4).
  6. Manually latch the LH front door.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use a pocket screwdriver to manually latch the door.
  7. Remove the LH front door glass. See Door Glass - Moving Glass - Front LH (Remove and Install).
  8. Disconnect MV power. See Disconnect MV Power.
  9. Remove the LH front door closeout panel. See Front and Rear Door Glass Regulator - Front Door LH Door Closeout Panel (Remove and Install).
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to remove the window regulator from the closeout panel assembly.
  10. Remove the LH front door latch. See Front and Rear Door Latch and Striker - Door Latch - Front LH (Remove and Install).
  11. Remove the LH door presenter. See Door Presenter - Front Door - LH (Remove and Replace).
  12. Remove the closure harness.
    Informational PurposesAn informational icon, calling your attention
    Note
    x3 clips, x1 grommet

Install

  1. Install the closure harness.
    Informational PurposesAn informational icon, calling your attention
    Note
    x3 clips, x1 grommet
  2. Install the LH door presenter. See Door Presenter - Front Door - LH (Remove and Replace).
  3. Install the LH front door latch. See Front and Rear Door Latch and Striker - Door Latch - Front LH (Remove and Install).
  4. Install the LH front closeout panel. See Front and Rear Door Glass Regulator - Front Door LH Door Closeout Panel (Remove and Install)
  5. Install the LH front door glass. See Door Glass - Moving Glass - Front LH (Remove and Install).
  6. Manually release the latch.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull the manual release cable away from the vehicle to unlatch.
  7. Reconnect MV power. See Disconnect MV Power.
  8. Close the LH front door.
  9. Check and adjust the gap and flushness.
    Informational PurposesAn informational icon, calling your attention
    Note
    Connect external window switch to help with adjustment.
  10. Open the LH front door.
  11. Install the LH front inner waist belt seal.
    Informational PurposesAn informational icon, calling your attention
    Note
    x6 rubber datums on either side
  12. Install the LH front door trim. See Front Door Trim Pad - Door Trim Front - LH (Remove and Install).
  13. Calibrate the window.
    Informational PurposesAn informational icon, calling your attention
    Note
    Press and hold down the selected window for 15 seconds. Roll up window and hold for 15 seconds. Test window by hard pressing to see if the auto roll function works.
  14. Raise the LH front window and close the LH front door.