2024-07-23

Speaker - Header - Rear - LH (Remove and Install)

Correction code 2121012051 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Remove the rear header trim. See Rear Header Trim.
  2. Disconnect the speaker electrical connector.
  3. Remove the bolt and release the tab that attaches the LH rear header speaker to the vehicle, and then pivot the speaker inboard to release it from the vehicle.
    2 Nm (1.5 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the LH rear header speaker into the vehicle, and then install the bolt and engage the tab that attaches the speaker to the vehicle.
    2 Nm (1.5 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Engage the datums, rotate the speaker outboard, and then install the bolt.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Connect the speaker electrical connector.
  3. Install the rear header trim. See Rear Header Trim.