23/07/2024 17:25:49

Bed Cargo Tub - Bed Cargo Tub Lid (Remove and Replace)

Correction code 1215014021 1215014022 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the tonneau cover.
  2. Open the tailgate.
  3. Remove the bed cargo tub lid strut. See Tonneau - Bed Cargo Tub Strut (Remove and Install).
  4. With assistance, remove the bolts (x4) that attach the bed cargo tub lid to the vehicle, and then remove the tub lid from the vehicle.
    5 Nm (3.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. With assistance, position the bed cargo tub lid into the vehicle, and then install and hand-tighten the bolts (x4) that attach the tub lid to the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Install the bed cargo tub lid strut. See Tonneau - Bed Cargo Tub Strut (Remove and Install).
  3. Remove the support from the bed cargo tub lid.
  4. Close the bed cargo tub lid.
  5. Verify gap and flush between the cargo lid and bed is within specification and adjust as needed.
    Informational PurposesAn informational icon, calling your attention
    Note
    Refer to CVIS.
  6. Open the bed cargo tub lid.
  7. Torque the bolts (x4) that attach the tub lid to the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  8. Close the bed cargo tub lid.
  9. Close the tonneau cover.
  10. Close the tailgate.