2024-07-23

Applique - C-Pillar - LH (Remove and Install)

Correction code 1220035031 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2024-03-26: Added step to remove/install sail baffle applique.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Remove the LH sail baffle applique. See Applique - Sail Baffle - LH (Remove and Install).
  2. Remove the LH C-pillar applique closeout. See Closeout - Applique - C-Pillar - LH (Remove and Install).
  3. Remove the bolt that attaches the LH C-pillar applique to the C-pillar.
    6 Nm (4.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  4. Release the clips (x2) that attach the LH C-pillar applique to the C-pillar, release the applique from the C-pillar, and then disconnect the electrical connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull the bottom of the pillar applique away from the C-pillar to release the clips, and then pull the applique downward to release it from the C-pillar.

Install

  1. Position the LH C-pillar applique to the C-pillar, connect the electrical connector, and then secure the clips (x2) that attach the applique to the C-pillar.
    Informational PurposesAn informational icon, calling your attention
    Note
    Slide the applique upwards, then push inwards to secure clips.
  2. Install the bolt that attaches the LH C-pillar applique to the C-pillar.
    6 Nm (4.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  3. Install the LH C-pillar applique closeout. See Closeout - Applique - C-Pillar - LH (Remove and Install).
  4. Install the LH sail baffle applique. See Applique - Sail Baffle - LH (Remove and Install).