23/07/2024 17:33:48

Remote and Passive Entry - Wheel Well Endpoint, BLE (Remove and Install)

Correction code 1745104031 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Place the vehicle into Service Mode. See Service Mode.
  3. Remove the LH front fender flare fore carrier. See Front and Rear Garnish - Carrier - Front Fender Flare Fore - LH (Remove and Install).
  4. Remove and discard the bolts (x2) that attach the LH front wheel well BLE endpoint to the vehicle, and then remove the BLE endpoint from the vehicle.
    1.5 Nm (1.1 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 bit

Install

  1. Position the LH front wheel well BLE endpoint into the vehicle, and then install new bolts (x2) that attach the BLE endpoint to the vehicle.
    1.5 Nm (1.1 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 bit
  2. Install the LH front fender flare fore carrier. See Front and Rear Garnish - Carrier - Front Fender Flare Fore - LH (Remove and Install).
  3. Unlock the Vehicle Gateway. See Gateway (Unlock).
  4. On the vehicle touchscreen, navigate to Driver Assist > Cameras > Clear Camera Calibration > Camera Input > ForwardFacing, and then tap Run to clear camera calibration.
  5. Exit Service Mode. See Service Mode.
  6. Raise the LH front window and close the LH front door.