2024-07-23

Puddle Lamp - Glovebox (Remove and Install)

Correction code 1405028011 1405028012 FRT 0.54 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Remove the glove box assembly. See Glovebox Assembly (Remove and Install).
  2. Disconnect the puddle lamp electrical connector, and then release the tabs (x4) that attach the lamp to the supercarrier assembly and remove it from the vehicle.

Install

  1. Position the puddle lamp into the vehicle, engage the tabs (x4) that attach the lamp to the vehicle, and then connect the electrical connector.
  2. Install the glove box assembly. See Glovebox Assembly (Remove and Install).