2026-08-09

BLE End Point - Front Rear (Remove and Install)

Correction code 1745104011 FRT 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH front door and lower the LH front window.
  2. On the touchscreen, touch Controls > Suspension > Very High to set the vehicle ride height to Very High.
  3. Place the vehicle into Service Mode. See Service Mode.
  4. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Install).
  5. Disconnect MV power. See Mid-Voltage Power (Disconnect and Connect) (Modify).
  6. Remove the frunk assembly. See Frunk Assembly (Remove and Install).
  7. Remove the front fascia assembly. See Front Fascia (Remove and Install).
  8. Release the locking tab and disconnect the front BLE endpoint electrical connector, remove the screws (x2) that attach the front BLE endpoint to the vehicle, and then remove the BLE endpoint from the vehicle.
    5 Nm (3.7 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T25 socket

Install

  1. Position the front BLE endpoint into the vehicle, install the bolts (x2) that attach the BLE endpoint to the vehicle, and then connect the electrical connector and engage the connector lock.
    5 Nm (3.7 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T25 socket
  2. Install the front fascia assembly. See Front Fascia (Remove and Install).
  3. Install the frunk assembly. See Frunk Assembly (Remove and Install).
  4. Reconnect MV power. See Mid-Voltage Power (Disconnect and Connect) (Modify).
  5. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Install).
  6. Exit Service Mode. See Service Mode.
  7. On the touchscreen, touch Controls > Suspension > Standard to set the vehicle ride height to Standard.
  8. Raise the LH front window and close the LH front door.