2026-08-09

Coathook and Maplight - LH (Remove and Install)

Correction code 1520068051 1520068052 1520068061 1520068062 FRT 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH doors and lower the LH windows.
  2. Remove the front header trim. See Trim - Header - Front (Remove and Install).
  3. Remove the LH mid A-pillar trim. See Trim - A-Pillar - Mid - LH (Remove and Install).
  4. Remove the LH upper A-pillar trim. See Trim - A-Pillar - Upper - LH (Remove and Install).
  5. Move the LH front seat fully forward.
  6. Remove the rear header trim. See Trim - Header - Rear (Remove and Install).
  7. Remove the LH cantrail trim. See Trim - Cantrail - LH (Remove and Install)
  8. Remove the screws (x4) that attach the LH coathook and maplight assembly to the cantrail trim, release the assembly from the tether, and then remove the assembly from the vehicle.
    1 Nm (.7 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T15 socket

Install

  1. Position the LH coathook and maplight assembly onto the cantrail trim, secure the assembly to the tether, and then install the screws (x4) that attach the assembly to the trim.
    1 Nm (.7 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T15 socket
  2. Install the LH cantrail trim. See Trim - Cantrail - LH (Remove and Install)
  3. Install the rear header trim. See Trim - Header - Rear (Remove and Install).
  4. Install the LH upper A-pillar trim. See Trim - A-Pillar - Upper - LH (Remove and Install).
  5. Install the LH mid A-pillar trim. See Trim - A-Pillar - Mid - LH (Remove and Install).
  6. Install the front header trim. See Trim - Header - Front (Remove and Install).
  7. Raise the LH windows and close the LH doors.