2026-08-09

Forged Bed Tiedown Assembly (Remove and Install)

Correction code 1215016051 1215016052 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Remove the LH rear bed closeout. See Bed Closeout - Rear - LH (Remove and Install).
  2. Remove the bolt and nut that attaches the forged bed tiedown to the vehicle, and then remove it from the vehicle.
    36 Nm (26.5 lbs-ft)
    7 Nm (5.2 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 13 mm socket
    • 10 mm socket

Install

  1. Position the forged bed tiedown to the vehicle, and then install the bolt and nut that attaches the tiedown to the vehicle.
    36 Nm (26.5 lbs-ft)
    7 Nm (5.2 lbs-ft)
    Note
    The bolt is torqued to 36 Nm and the nut to 7 Nm.
    Tip
    Use of the following tool(s) is recommended:
    • 13 mm socket
    • 10 mm socket
  2. Install the LH rear bed closeout. See Bed Closeout - Rear - LH (Remove and Install).