2026-08-09

Trim - Header - Rear (Remove and Install)

Correction code 1520068071 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2024-04-09: Updated step and images for trim with 12 clips.
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Move the LH front seat fully forward.
  3. Open the LH rear door and lower the LH rear window.
  4. Release the clips (x12) that attach the rear header trim to the vehicle, and then remove the header trim from the vehicle.
    Note
    Clip count and location may vary depending on vehicle build.
    Figure 1. 12 clips
    Figure 2. 11 clips

Install

  1. Position the rear header trim into the vehicle, and then secure the clips (x12) that attach the header trim to the vehicle.
    Note
    Replace any missing or damaged clips.
    Note
    Clip count and location may vary depending on vehicle build.
    Figure 3. 12 clip trim
    Figure 4. 11 clips
  2. Raise the LH rear window and close the LH rear door.
  3. Restore the LH front seat back to its original position.
  4. Raise the LH front window and close the LH front door.