2024-07-23

Dash Panel - IP Glovebox Assembly (Remove and Install)

Correction code 1405027021 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the lower instrument panel. See Dash Panel - Instrument Panel Lower Assembly (Remove and Install).
  2. Remove the RH EPP clip.
  3. Release the locking tab, and then disconnect the glovebox USB connector.
  4. Remove the screws (x5) that attach the glovebox to the vehicle, release the harness clip, disconnect the electrical connector, and then remove the glovebox from the vehicle.
    2 Nm (1.5 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket

Install

  1. Position the glovebox into the vehicle, install the harness to the harness clip, connect the electrical connector, and then install the screws (x5) that attach the glovebox to the vehicle.
    2 Nm (1.5 lbs-ft)
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Align the datums to prevent gear from damaging harness.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  2. Connect the glovebox USB connector, and then engage the locking tab.
  3. Install the RH EPP clip.
  4. Install the lower instrument panel. See Dash Panel - Instrument Panel Lower Assembly (Remove and Install).