2024-10-24

Rearview Mirror - Glare Shield (Remove and Install)

Correction code 1505103021 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-10-24: Added step to remove overhead console assembly in beauty cover link.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Remove the rearview mirror beauty cover. See Rearview Mirror - Beauty Cover (Remove and Install).
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to remove the interior camera from the cover.
  2. Remove the GLONASS GPS antenna. See Antennas and Amplifiers - Milkweed GNSS Antenna Assembly (Remove and Install).
  3. Release the securing tabs (x2) that attach the rearview mirror glare shield to the windshield bracket, and then remove the glare shield from the bracket.