2024-07-23

Harness - Trim - A-Pillar - LH (Remove and Install)

Correction code 1710109031 1710109032 1710109041 1710109042 FRT 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Remove the front header trim. See Trim - Header - Front (Remove and Install).
  3. Remove the LH mid A-pillar trim. See Trim - A-Pillar - Mid - LH (Remove and Install).
  4. Remove the LH upper A-pillar trim. See Trim - A-Pillar - Upper - LH (Remove and Install).
  5. Disconnect the LH A-pillar trim harness electrical connectors (x4), release the clips (x4) that attach the harness to the trim assembly, and then remove the harness from the trim assembly.

Install

  1. Position the LH A-pillar trim harness into the LH upper A-pillar trim, secure the clips (x4) that attach the harness to the trim assembly, and then connect the harness electrical connectors (x4).
  2. Install the LH upper A-pillar trim. See Trim - A-Pillar - Upper - LH (Remove and Install).
  3. Install the LH mid A-pillar trim. See Trim - A-Pillar - Mid - LH (Remove and Install).
  4. Install the front header trim. See Trim - Header - Front (Remove and Install).
  5. Raise the LH front window and close the LH front door.