2026-08-09

GPS Antenna (Remove and Install)

Correction code 2135011041 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2024-10-24: Added step to remove overhead console assembly in rearview mirror beauty cover procedure link.
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Remove the rear view mirror beauty cover. See Beauty Cover - Rearview Mirror (Remove and Install).
    Note
    It is not necessary to remove the interior camera from the cover.
  3. Release the connector lock and disconnect the electrical connector, remove the screw that attaches the GLONASS GPS antenna to the vehicle, and then slide the antenna out of the glare shield to remove it from the vehicle.
    0.8 Nm (7 lbs-in)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T10 bit

Install

  1. Position the GLONASS GPS antenna into the glare shield, install the screw that attaches the antenna to the vehicle, and then connect the electrical connector and engage the connector lock.
    0.8 Nm (7 lbs-in)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T10 bit
  2. Install the rear view mirror beauty cover. See Beauty Cover - Rearview Mirror (Remove and Install).
  3. Raise the LH front window and close the LH front door.