23/07/2024 17:34:55
Tailgate Latch and Striker - Bumpstop, Tailgate (Remove and Install)
Correction code
1133116021
1133116022
FRT
0.06
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.
Remove
- Open the tailgate.
- Release the LH rear lamp closeout applique. See Truck Bed Exterior Trim - Rear Lamp Closeout Applique - LH (Remove and Install).
-
Rotate the LH tailgate bumpstop
counterclockwise to release it from the vehicle.
Install
-
Position the LH tailgate bumpstop into the vehicle, and then rotate the bumpstop
clockwise to secure it to the vehicle.
- Install the LH rear lamp closeout applique. See Truck Bed Exterior Trim - Rear Lamp Closeout Applique - LH (Remove and Install).
- Close the tailgate.