Check Strap - Front Door - LH (Remove and Replace)
Correction code
1133071132
FRT
0.42
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
- 2024-03-05: Updated check device joint bolt and torque.
Remove
-
Remove the LH front door closeout
panel. See Front and Rear Door Glass Regulator - Front Door LH Door Closeout Panel (Remove and Install).
NoteIt is not necessary to remove the window regulator from the closeout panel.
- Remove the LH glass run seal. See Front and Rear Door Seals - Glass Run Seal, Front Door, A-Pillar (Remove and Install).
-
Release the door check device
closeout, and then remove the fasteners (x3) that attach the LH front door check device
to the vehicle.
TIpUse of the following tool(s) is recommended:
- Torx T40 socket or 13 mm hex
- 10 mm socket
NoteIf the vehicle has a Torx T40 bolt, remove and discard the bolt, and then replace it with a 13 mm hex bolt (1623708-00-A) that is to be installed later in this procedure. - Rotate the LH front door check device 90 degrees, and then remove the door check device from the vehicle.
Install
- Position LH front door check device into the vehicle, and then rotate the door check device 90 degrees into position.
-
Install the fasteners that attach the
LH front door check device to the vehicle, and then secure the closeout.35 Nm (25.8 lbs-ft)8.5 Nm (6.3 lbs-ft)NoteThe 10 mm nuts are torqued to 8.5 Nm and the 13 mm hex bolt is torqued to 35 Nm.TIpUse of the following tool(s) is recommended:
- 13 mm hex
- 10 mm socket
- Install the LH glass run seal. See Front and Rear Door Seals - Glass Run Seal, Front Door, A-Pillar (Remove and Install).
- Install the LH front door closeout panel. See Front and Rear Door Glass Regulator - Front Door LH Door Closeout Panel (Remove and Install).